Removing the Top:

First, prepare the can. Place the sleeve on a table. Insert the first lifter through the sleeve. Drop and lock it into place at the bottom. Push the can fully into the sleeve.

Preferably, to inhibit the can's upward motion, you should lock the can into the sleeve with one or more pushpins that pierce the can's side at the sleeve's top anchor holes.

Preferably, to inhibit the can's rotation, you should lock the can into the sleeve with one or more pushpins that pierce the can's side at the sleeve's top anchor holes. Two pushpins at opposite sides of the can work very well, since they can each bear half the pressure created during your cut. If you go the two-pushpin route, you'll want to twist the can slightly in the direction of your intended motion; then lock it in place further with the second pushpin. This keeps the can snugly in place during during the cut.

If the pushpin holes would clash with your design – or if you find using pushpins to be inconvenient or unnecessary – then you can allow the can to rotate relatively freely when needed so long as you're careful to be pressing gently down on the top of the can while cutting. It's important to keep the can from drifting upward as you use the slider, or else you will get an uneven result. Try to maintain a consistent penetration angle between the slider and the can wall. I find that dragging the bottom of the metal part of the slider along the top ledge of the sleeve does the trick.

Try for smooth motion with steady pressure as you drag the slider around the rim. You may need to wiggle the slider back-and-forth in the sideways direction a bit to re-start a stalled cut.

As you make your slide, you'll want the slider to always be oriented perpendicularly to the slot – both in its length-direction and its circumferential-direction. The slider should be pointed directly at the central axis of the can, and the imaginary line of the slider should make a 90 degree angle with the axis. This is all easier to do than it sounds.

The last bit of the cut around the circumference of the can must be done carefully. You'll notice that your non-cutting hand folds down the far end of the can top at an angle once you've removed some support material from the other side. This makes the last part more difficult to remove. So, make sure that once you start feeling resistance to the slider, you keep the top of the can parallel to the ground and elevated in its proper original position while still maintaining light downward pressure. (The light pressure is so the remaining bit doesn't elevate slightly out of the can). If this last step is difficult for you, then the easiest thing to do is to stop circling the slider when you feel resistance, tear off the top manually, and use scissors to remove the last remnants.

If any remnants remain from the cut, use the side of the metal part of the slider to crease and flatten the remnants hard against the top rim of the sleeve. They'll be easy to remove after that. If you don't remove all the tiny remnants protruding out from the rim of the can, you'll have difficulty re-inserting the can back into the sleeve if you're needing to remove the bottom.

Be sure to scrape the slider along the inner rim of the can while it's still fully inserted in the sleeve to deburr any sharp edges.


To learn specific designs, click: DESIGNS